PRODUCTS

RO evaporator

DATE:2016-3-9   VIEWS:1699

Product name: RO evaporator

Product introduction

By the effective heating, condenser, evaporator, the effect separator hot-pressing pump, vacuum system, the effect of material liquid pump, condensation drainage pump and operation platform, electrical instrumentation control cabinet, valves and piping system.

Scope of application

This evaporator, is applicable to salt, milk, starch, glucose, xylose, pharmaceutical, chemical and biological engineering, environmental engineering, waste liquid recycling etc for evaporation and concentration, low temperature continuous has high heat transfer efficiency, shorter time for heating the material such as the main characteristics, so especially suitable for heat-sensitive, viscosity and foam materials.

Device characteristics

1. The whole heating system with steam heating uniformity, material liquid to liquid film flow evaporation, so has high heat transfer efficiency and other main characteristics of short heating time. Such as relocation compression pump, more energy saving, low steam consumption and low cooling water circulation.

2. The material flow speed down the tube wall pressure evaporation, adapt to the larger material liquid viscosity evaporation concentration.

3. Because the material in each root canal into membrane evaporation and material liquid heating time is very short, so evaporation and concentration is very good, especially for food larger preserve the nutrition of the food.

4. Under the effect of vacuum evaporation process, both to ensure that the material of the health requirements, at the same time to ensure the requirements of environmental protection, at the same time, greatly reduces the evaporation temperature, plus configuration compression pump, part of the secondary steam by hot-pressing pump suction mixed with raw steam again, save raw steam, both at the same time by hot-pressing pump heating steam spray fog shaped into the shell, steam quickly spread, mild material liquid heating, so the suitable concentration of thermal sensitive material.

5. The equipment is suitable for evaporation and concentration, foam materials due to the material liquid into membrane evaporation in the heating tube, which form the gas-liquid separation, in effect at the bottom of the body at the same time, most of the material liquid is siphoned off, only a little part of material liquid and all secondary steam into the separator separation, the whole process of material liquid forming no too big impact, to avoid the formation of bubbles.