Scope of falling film evaporator

·

Widely used in glucose, starch sugar, oligosaccharides, malt sugar, sorbitol, fresh milk, fruit juice, vitamin C, maltodextrin, etc. The concentration of aqueous solution. And can be widely used in monosodium glutamate, the treatment of waste liquid alcohol, fish meal, etc.

·

The equipment for continuous operation under the condition of vacuum low temperature, high evaporation capacity, saving energy and reducing consumption, low operation cost, materials can be dealt with the most earth to keep the original color, aroma, taste and ingredients. In food, medicine, food processing, beverage, light industry, environmental protection, chemical industry and so on many of the evaporation of water or organic solvent solution concentration are widely used.

·

Falling film evaporator system

Equipment body by Ⅰ effect heater, condenser, separator, hot pressing pump, vacuum system, sterilizer, insulation tube, material pump, water pump, valve, pipe and meter counter unit. This equipment is all contact with material are made of high quality stainless steel.

·

Falling film evaporator key features:

1. The whole heating system with steam heating uniformity, material liquid to liquid film flow evaporation, so has high heat transfer efficiency and other main characteristics of short heating time. Such as relocation compression pump, more energy saving, low steam consumption and low cooling water circulation.

2. The material flow speed down the tube wall pressure evaporation, adapt to the larger material liquid viscosity evaporation concentration.

3. Because the material in each root canal into membrane evaporation and material liquid heating time is very short, so evaporation and concentration is very good, especially for food larger preserve the nutrition of the food.

4. Under the effect of vacuum evaporation process, both to ensure that the material of the health requirements, at the same time to ensure the requirements of environmental protection, at the same time, greatly reduces the evaporation temperature, plus configuration compression pump, part of the secondary steam by hot-pressing pump suction mixed with raw steam again, save raw steam, both at the same time by hot-pressing pump heating steam spray fog shaped into the shell, steam quickly spread, mild material liquid heating, so the suitable concentration of thermal sensitive material.

5. The equipment is suitable for evaporation and concentration, foam materials due to the material liquid into membrane evaporation in the heating tube, which form the gas-liquid separation, in effect at the bottom of the body at the same time, most of the material liquid is siphoned off, only a little part of material liquid and all secondary steam into the separator separation, the whole process of material liquid forming no too big impact, to avoid the formation of bubbles.

6. For food, evaporating equipment can have sterilization function at the same time, the material after preheating first, and then into the sterilizer, reach more than 94 degrees, 24 seconds, which entered a work efficiency, rapid flash of material, temperature in an instant.

7. The equipment can be equipped with CIP cleaning system, the realization of in-place cleaning, a complete set of equipment is easy to operate, no dead Angle.

Equipment in and out of the material. 8.

9. The equipment can be configured automation system, realize the feed rate of the automatic control, the heating temperature automatic control, automatic discharging concentration control, automatic control, cleaning can also be equipped with a sudden power failure, failure protection for sensitive material. Other safety, alarm and other automation and control.